Surfaces you can wipe down, painted zone by zone with the department still running.
Wards, corridors, consulting rooms and clinics painted in cleanable finishes, zone by zone, with dust contained and the work planned around your theatre lists, admissions and cleaning rounds.
- Free site inspection
- Written, itemised quote
- 1-year workmanship warranty
- Same-day callback
At a glance
What's different about painting a hospital or clinic?
The building stays open, and the finish has to survive daily disinfection. We work one zone at a time behind barriers, keep escape routes and trolley access clear, and specify coatings meant to be wiped down rather than ones that go patchy and shiny when they're. Sequencing around ward rounds, theatre lists and OPD hours matters just as much as the paint itself.
When this is the answer, and when it is not.
Sending you to the wrong service wastes your money and our time. This is how to tell.
This is likely right if
- Ward, corridor and OPD walls look tired, or daily wiping has worn the finish into patchy shine
- Trolley, bed and wheelchair impact has knocked the plaster and paint back at dado height
- A clinic or floor is changing use or department and needs bringing back to one consistent finish
- You need the work staged so no department has to close completely
Something else comes first if
- Operation theatres and other sealed clean areas lined with modular or vinyl-clad panels, those are resurfaced or replaced by the panel supplier, and paint doesn't bond to a vinyl or laminate panel face, so it lifts first at the joints and at the points that get wiped most, and you lose the seamless surface the panel was fitted to give you
- Walls with active seepage behind wash-up areas or under AHU ducting, the water source has to be traced and treated first, or mould comes back through the new coat
- Zones where medical gas runs, nurse call cabling or false ceilings are still being altered, services work should finish before painting, not cut into it afterwards
What the service includes.
Zone survey and method plan
We walk each department with your engineering and nursing in-charge, list which zones can be released and when, and agree the sequence in writing before anyone starts.
Dust and air containment
Sheeted barriers at the zone boundary and doorways sealed, sanding damped down or done with extraction instead of dry rubbing, debris bagged inside the zone and floors wiped rather than swept.
Services and safety fittings masked
Medical gas outlets, nurse call points, sprinkler heads, detectors, pipeline colour coding and fire door labels are masked and kept legible, none of these are painted over, and covered detectors are uncovered before we leave the zone.
Impact repair and levelling
Trolley and bed damage at dado height cut back, filled and levelled, along with gouges around door frames and lift lobbies, so the finish sits flat instead of being papered over a dent.
Primer and cleanable finish coats
A primer chosen for what's already on the wall, then washable finish coats to the sheen and coat count stated in your quotation, a film meant to be wiped, not one that burnishes where the cleaning cloth goes.
Zone-by-zone handback record
Each area cleaned and cleared of our waste before the next opens, with colour, sheen and coat count recorded by room and corridor for your maintenance file.
Not included, or quoted separately
- Operation theatre and clean room panel systems, laminated cladding and sheet wall linings, those are fitted, not painted
- Medical gas pipeline, nurse call and electrical work, and anything that penetrates a lead-lined radiology wall
- Terminal cleaning, disinfection or fumigation of a zone after we hand it back, that stays with your housekeeping protocol
- Waterproofing and damp source treatment, including seepage behind wash-up areas and around AHU ducting, quoted separately
- Supply and fitting of corner guards, crash rails and door protection sheets, though we'll mark where they're needed
The sequence.
Walkthrough and zoning
We walk the facility with your engineering and infection control leads, measure each area and mark which zones can be released together without cutting a working department in half.
Specification by area
Sheen and colour agreed room type by room type, a corridor wiped down daily needs a different finish to an administrative office, with sample patches put up on your own walls under your own lighting.
Method statement and permits
Working hours, barrier positions, access and waste routes, escape route protection and detector isolation written down and cleared through your permit-to-work process before we start.
Contain and prepare
Barriers up, fittings masked, detectors covered, then scraping, filling, levelling and sanding with the dust kept inside the zone rather than travelling down the corridor.
Prime and coat
Primer and finish coats to the agreed specification, with the stronger-smelling enamel work on doors, grills and railings kept to low-occupancy windows and the area ventilated before it reopens.
Clean, inspect and hand back
Detectors uncovered, masking removed, the zone cleaned and walked with your in-charge, snags closed, and only then do we open the next zone.
What moves the price on this job.
We do not publish a rate, because it would change once someone measured your property. These are the variables that decide it.
- Measured wall and ceiling area by zone, not the floor area of the department
- How much of the work has to happen at night or inside short handover windows
- The extent of impact damage at dado height, since cutting back, filling and levelling knocked plaster takes far longer per metre than coating a wall that's already sound
- How cleanable the finish has to be in each area, treatment rooms and corridors are specified differently to offices and waiting areas
- The number of separate zones, since each one carries its own containment, masking and handback
- Whether doors, frames, grills and railings are included, as these need different products and different working hours
Hospital and Clinic Painting — your questions.
Can you paint while the ward is occupied?
Yes, in zones. We take one area at a time behind temporary barriers, keep escape routes and trolley access clear, and hand the zone back cleaned before the next one opens. Rooms are done at turnover rather than around an occupied bed. Which zones can be released, and in what order, is agreed with your nursing in-charge before the quotation is finalised.
How do you keep dust out of clinical areas?
Physical separation first: sheeted barriers at the zone boundary and doorways sealed. Sanding is damped down or done with extraction rather than dry rubbing, debris is bagged inside the zone, and floors are wiped instead of swept. Smoke detectors inside the working area are covered while we work and uncovered before handback. Your infection control team sets the standard and we work to it.
Will the paint smell affect patients and staff?
Water-based emulsion on walls and ceilings is low in odour and clears quickly with the zone ventilated. Enamel on doors, grills and railings is a different matter, it is stronger and it lingers, so we programme that work for low-occupancy windows and keep the area closed and ventilated until it has gone off. We flag which areas need that handling at the survey.
Does painting help with infection control?
Not by itself, and we won't tell you otherwise. What a coating gives you is a smooth, sound, wipeable surface with no open cracks or flaking edges for soil to lodge in, so your cleaning regime actually reaches the wall. Infection control comes from cleaning, ventilation and layout. Paint supports that work; it doesn't replace any part of it.
Our corridor walls keep getting damaged by trolleys. Will repainting fix that?
Repainting makes it look right again, but it will be knocked back in the same places soon enough. The damage is mechanical, so the fix is mechanical: corner guards on every exposed corner and a crash rail at the height trolley and bed bumpers actually strike. We mark where they're needed at survey, and paint around them once they're fitted.
Let us look at your walls first.
Tell us about the property and we will set up a free colour and wall inspection. You get a written, itemised quotation afterwards, with no obligation to go ahead.
- We call you back the same day to get a picture of the property and the surfaces.
- We agree a time and come out for the free inspection.
- You get the written scope and itemised quotation.
- Nothing starts until you approve it.